- 您现在的位置：买卖IC网 > Sheet目录840 > B41041A6228M (EPCOS Inc)2200UF 50V 18X35.5 SINGLE END
Cautions and warnings
General
Also see “Important notes” on page 24.
1
Aluminum electrolytic capacitors have a bi-polar structure. This is marked on the body of the
capacitor. A capacitor must not be mounted with reversed polarity. The application of an AC
or reverse voltage may cause a short circuit or damage the capacitor. Bi-polar capacitors
must not be used in AC applications, where the polarity may be reversed in the circuits or is
unknown.
2
The DC voltage applied to the capacitor terminal must not exceed its rated operating voltage,
as this will result in a rapid increase of the leakage current and may damage the capacitor. It
is recommended to operate the capacitor at 70 –80% of its rated voltage to optimize its serv-
ice life.
3
The ripple current applied to the capacitor must be within the permitted range. An excessive
ripple current leads to impaired electrical properties and may damage the capacitor. Note that
the sum of the peak values of the ripple voltage and the DC operating voltage must not ex-
ceed the rated DC voltage.
4
Capacitors must be used within their permitted range of operating temperature. Operation at
room temperature optimizes their service life.
5
Capacitors with case diameter ≥ 8 mm are equipped with a safety vent. In capacitors fitted
with a lead or soldering lug, the safety vent is usually located at the base of the case. It needs
sufficient space around it to operate optimally. The following dimensions are recommended:
for case diameter d = 8 to 16 mm, more than 2 mm; for d =18 to 35 mm, more than 3 mm;
and for d = 42 mm or more, more than 5 mm.
6
Capacitors should not be mounted with the safety vent face down on the board. Do not locate
any wire or copper trace near the safety vent. Do not reverse the voltage, as this may result
in excess pressure and the leakage of electrolyte.
7
Gas is released through the safety vent when the pressure inside the capacitor is too high. A
gaseous liquid around the safety vent does not indicate a leakage of electrolyte.
8
The capacitor should be stored under conditions of normal temperature and in a non-acid,
non-alkali environment of normal humidity. Exposure to high temperatures, for example un-
der direct sunlight, will reduce its operating life. If the capacitor is stored in an environment
containing acids or alkalis, the solderability of the leads may be affected.
9
The leakage current of an aluminum electrolytic capacitor may increase after a long period
of storage. After such storage, the capacitor must be aged by applying the rated operating
voltage for 6 –8 hours before use.
10
Manual soldering:
a Soldering must be performed within the specified conditions.
Bit temperature: 350 ° C; application time of soldering iron: 3 seconds.
b Ensure that the soldering iron does not touch any part of the capacitor body.
Please read Cautions and warnings and
Important notes at the end of this document.
22
08/08
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
B41042A7338M
3300UF 35V 18X40 SINGLE END
B41043A3109M
10000UF 10V 18X40 SINGLE END
B43086A5336M
33UF 450V 16X31.5 SINGLE END
B43088A5476M
47UF 450V 18X35.5 SINGLE END
B62152A001X001
FERRITE DBL APERTURE CORE 14.5MM
B64290L0038X038
FERRITE TOROID 10MM OD
B64290L0040X830
FERRITE TOROID 58.3MM OD
B64290L0044X038
FERRITE TOROID 12.5MM OD
相关代理商/技术参数
B41041A6334M
功能描述:铝质电解电容器 - 带引线 0,33 F 50V 5x11 SINGLE ENDED RoHS:否 制造商:Kemet 引线类型: 电容:220 uF 容差:20 % 电压额定值:25 V 工作温度范围: 端接类型:Radial 外壳直径:8 mm 外壳长度:11 mm 引线间隔:5 mm 产品:General Purpose Electrolytic Capacitors 封装:Bulk
B41041A6334M 7
制造商:TDK-EPC 功能描述:- Ammo Pack
B41041A6334M 8
制造商:TDK-EPC 功能描述:- Ammo Pack
B41041A6334M 16
制造商:TDK-EPC 功能描述:- Ammo Pack
B41041A6334M16
功能描述:铝质电解电容器 - 带引线 0,33 F 50V 5x11 SINGLE ENDED RoHS:否 制造商:Kemet 引线类型: 电容:220 uF 容差:20 % 电压额定值:25 V 工作温度范围: 端接类型:Radial 外壳直径:8 mm 外壳长度:11 mm 引线间隔:5 mm 产品:General Purpose Electrolytic Capacitors 封装:Bulk
B41041A6334M7
功能描述:铝质电解电容器 - 带引线 0,33 F 50V 5x11 SINGLE ENDED RoHS:否 制造商:Kemet 引线类型: 电容:220 uF 容差:20 % 电压额定值:25 V 工作温度范围: 端接类型:Radial 外壳直径:8 mm 外壳长度:11 mm 引线间隔:5 mm 产品:General Purpose Electrolytic Capacitors 封装:Bulk
B41041A6334M8
功能描述:铝质电解电容器 - 带引线 0,33 F 50V 5x11 SINGLE ENDED RoHS:否 制造商:Kemet 引线类型: 电容:220 uF 容差:20 % 电压额定值:25 V 工作温度范围: 端接类型:Radial 外壳直径:8 mm 外壳长度:11 mm 引线间隔:5 mm 产品:General Purpose Electrolytic Capacitors 封装:Bulk
B41041A6335M
功能描述:铝质电解电容器 - 带引线 3,3 F 50V 5x11 SINGLE ENDED RoHS:否 制造商:Kemet 引线类型: 电容:220 uF 容差:20 % 电压额定值:25 V 工作温度范围: 端接类型:Radial 外壳直径:8 mm 外壳长度:11 mm 引线间隔:5 mm 产品:General Purpose Electrolytic Capacitors 封装:Bulk